1949 BSA 250cc



1949 BSA 250cc

I have been able to source this gem of a bike from a guy in Lismore NSW.

It is all there and only requires some tender loving care to bring it back to its condition as purchased. Looking forward to the challenge.

Comments

  1. lapsedrawJune 30, 2021 at 12:23 PM

    Going to be an bike grandpa ! Very excited to see the end result !

    ReplyDelete
  2. max andrew WaglandJune 30, 2021 at 2:18 PM

    you never stop. good onya mate. Cheers
    Max

    ReplyDelete

Post a Comment

Popular posts from this blog

1938 Scott Flying Squirrel

Image
Photos of Scott Flying Squirel for guidance in my rebuild 1938 Scott Flying Squirrel Whenever I source a vintage bike as you have seen previously I build a record of detailed photos of the condition of the bike as required which is in valuable in assisting the the total refurbishment The photos below have been taken in no particular sequence History of Scott Flying Squirrel I thought it appropriate that a statement should be included about the origins of this bike The Squirrel name was used for Scott motorcycles since 1921 but with the death of the founder Alfred Angas Scott in 1923 the unorthodox Scott two-stroke motorcycles began to become more conventional. Development of the three-speed Scott Flying Squirrel began in 1922 as the company was in severe debt and faced receivership. Launched at the 1926 Earls Court motorcycle show, the Flying Squirrel was expensive - nearly twice the cost of a sporting four-stroke motorcycle of the time.[1] The unique water-cooled circulation used a co
Read more

1952 Triumph Thunderbird 650cc

Image
1952 Triumph Thunderbird 650cc This of course then became an addiction and I acquired a 1952 650cc Triumph Thunderbird which looked complete, but in fact the guy I bought it from had obviously dismantled the engine, discovered problems and reassembled with only one piston and con rod. I magnamiously decided no point in challenging him, and subsequently completed a full and total dismantling and began a rebuild. HISTORY OF DEFECTS ENCOUNTERED DURING RESTORATION of TRIUMPH THUNDERBIRD It is of interest to highlight the issues that I encountered during the rebuild, and these are addressed in no particular order below; TELESCOPIC FORKS Upon dismantling I found the cup was jammed in the pressure tube body, I elected to replace both components, it is important to ensure that assembled forks are of identical length overall. It was a challenge compressing the spring on reassembly,  I made a compression jig to allow cap nut to be fitted. See photos below;               FRAME Frame was undercoat
Read more